Arm Settings

images/download/attachments/122259566/CmdArmSettings.svg

This command allows you to set the parameters of the connected measurement device.

Requirements

Connect the arm, and launch the command.


  • Scan measurement mode section provides you the possibility to modify the action of the measurement button in case of SCANNING:

    • One measure per push: user needs to click one time to measure only one stripe.

    • Continuously when button down: user needs to keep the button pressed to scan clouds. If user presses the button, the measure is launched and when he releases the button, the measure is stopped.

    • On / Off switch: user needs to click twice, one time to launch and another time to stop the measure.

  • Use sound must be checked if user wants to make a sound when the arm buttons are pressed.

  • Grid angle: the limit angle above which a new grid will be created while scanning.

  • RDS Control Panel button will be available if the connected arm is connected through RDS. It will open the specific arm interface.

Notes

  • All options defined in this command are also available directly on the arm software interface.

  • If there is an error while connecting the arm, the command will not be displayed, and replaced by this message: Retry connection button will restart the connection.