Cut and Fill
This command calculates, according to a given axis, the embankment and excavation of two models, having or not the same contours (in this case the volume is approximated).
Select 2 meshes and launch the command. The 2 meshes should not be closed.
Note
Volumes will only be calculated within regions where there is coverage within both the surfaces used for volume calculations. No volumes will be computed within regions where there is coverage by only one surface.
This can happen for main external borders and for all holes. In such cases, a warning message, telling you the result should be interpreted as an approximation, is displayed. Thus, to get relevant results, check the input meshes haven't plenty of unwanted holes.
Choose a direction to compute the cubature. The points from one mesh will be projected on the other mesh along this direction. If you are working on a road project for example, you can choose the Z direction. if you don't know which direction to choose, you can choose Automatic so that the software will find the best direction.
Choose the unit in which you want to have the resulting volumes.
The command calculates the following volumes:
volume over mesh n°1 and under mesh n°2 represents excavations.
volume under mesh n°1 and over mesh n°2 represents embankments.
difference of the 2 previous volumes.