Draw
This command constructs new CAD curves.
Requirements
No selection is required to launch the command.
Click points inside the graphic scene. If you need more information: refer to Define points . These points will be the "passing" points for the curve (passing exactly by all points).
If you want to delete the last point, press Del or BackSpace key.
If you want to exit the command without validating the current CAD curve, use the Esc key.
When you have finished the CAD curve, press Enter key. You can then start a new CAD curve.
If you have finished drawing CAD curves, press again Enter or Esc key to close the dialog box.
Tip & Trick
Press C to close/unclose the curve.
Notes
Positions of control points are reset after each new click or point deletion.