Cut and Fill
This command calculates, according to a given axis, the embankment and excavation of two models, having or not the same contours (in this case the volume is approximated).
Select 2 meshes and launch the command. The 2 meshes should not be closed.
Note
Volumes will only be calculated within regions where there is coverage within both the surfaces used for volume calculations. No volumes will be computed within regions where there is coverage by only one surface.
This can happen for main external borders and for all holes. In such cases, a warning message, telling you the result should be interpreted as an approximation, is displayed. Thus, to get relevant results, check the input meshes haven't plenty of unwanted holes.
|
|
Create a report
This command automatically creates reporting data in your document. This object stores your results so as to create a report later.
From the treeview click on the magnifier icon to launch the report editor (or launch Report Editor). Then, each object stands for a chapter which can be added to your report.
Refer to Reporting to learn how to customize your report.